| Phenomenon |
Reasons |
Maintenance |
| No power or electricity leaking protection device is activated |
1. Electricity leaking protection device cut off
power source when electricity line is not well
connected.
2. Power or electricity circuit have phenomenon
of electricity leaking. |
1. check and reconnect the wiring system.
2. check the power source, electricity
circuit and ground line. |
Water Jets are
not working. |
1. check the system whether is on.
2. the impeller of water pump doesn't rotate.
3. water pump is broken which caused by
working without water coming in. |
1. turn on the system.
2. check through and remove the garbage
which is inside the pump. Switch pipe
can be removed.
3.install a new water pump |
The intensity of
hydro-massage
cannot be adjusted |
1. water pump's suction has not enough power.
2. air adjustment valve is abnormal.
3. jets or nozzles are blocked. |
1. check the water pump whether is working normally
2. change the air adjustment valve.
3. remove things which are blocking the jets. |
Water leaks from
the pipes
|
1. seal ring is broken.
2. screws doesn't lock tightly.
3. pipes doesn't seal properly. |
1. chang seal ring.
2. lock the screws tightly.
3. re-seal the silicone.
4. change water pipe |
Jets shower can
not be work. |
1. voltage is abnormal
2. Switch cannot be work
3. control panel cannot be work.
3. water in electromagnetism valve is be blocked |
1. please use it at the normal situation of voltage.
2. check and change the switch.
3. maintain and change the control panel.
4. get rid of mess of the jets. |
| No lighting |
1. The bulb is broken.
2. power line is disconnected.
3. control panel is broken. |
1. change a new bulb..
2. re-connect the circuit..
3. maintain or change control panel |
| Cleaning and Maintenance: |
1. The daily maintenance should be cleaned with ordinary
detergent and soft cloth. Please do not use the detergent which
contains acetone or ammonia liquid. If there marks or something
like glue on the surface of bathtub, just polish it with soft
cloth dipping with gas.
2. If there are scratches on bathtub surface, please polish it
with 1500# frosted paper dipping with liquid and burnish it with
toothpaste. It will be shining again after that.
3. If there are furring on the surface of bathtub, it can be take
away by mild acid detergent, for example wipe the bathtub with
lemon juice or vinegar which be heated.
4. Do not wipe the chrome plated spare parts all the time, and
do not get in touch with chemical detergent etc. Otherwise the
surface of chrome plated will be destroyed. The product should
be clean by soft cloth other than coarse cloth.
5. To check the water pipe regularly in order to avoid troubles
from crack of water pipes or blocked inside.
6. If there are something such as hair stuck inside the jets,
then just to twist out the jets and remove it.
7. To clean hydro-massage equipment: To full fill hot water which
is 40'C, and pour 2g/L detergent, start hydro-massage function
more than 5 minutes, then turn off the massage function and drain
out the water. Next, to full fill cold water and start hydro-massage
function for 3 minutes, then turn off the massage function and
drain out the water, at last, to dry the bathtub with towel.
8. Filter should be clean once a week.
9. Keep out from combustibles and goods which over 80°C to
avoid fire disaster and damage the product.
10. The bathtub should be transported carefully. Do not lay heavy
things on it and do not bump and shaking the tub. If the bathtub
has not been used for a long time, drain out the water of the
bathtub and keep it in a dry and ventilate environment. Avoid
corrosive gas. |
